Configure the SSH Rekey Data Limit Threshold

Use the following procedure to limit data transmission during the session.

Procedure

  1. Enter Global Configuration mode:

    enable

    configure terminal

  2. Enter the following command:

    ssh rekey data-limit <1–6>

Example

Configure the data limit to 2 GB:

Switch:1>enable
Switch:1#configure terminal
Enter configuration commands, one per line.  End with CNTL/Z.
Switch:1(config)#ssh rekey data-limit 2

Variable Definitions

The following table defines parameters for the ssh rekey data-limit command.

Variable

Value

<1–6>

Specifies the SSH rekey data limit in GB. The default is 1 GB.
9039040-00 Rev AB